User's Manual

LAN
•
Make sure that the site LAN is operating
• Check the LAN connections to the repeater
• Reboot the Channel Controller card and observe the LED indicators on this card. The
green LEDs should remain on, indicating that a network connection is present. If not,
replace the Channel Controller card.
SIte Controller not communicating
over LAN
• Verify the repeater has supplied AC power
• Make sure that the site LAN is operating
• Check the LAN connections to the repeater
• If this repeater has an installed Site Controller card, reboot the Site Controller card
and observe the LED indicators on this card. The green LEDs should remain on,
indicating that a network connection is present. If not, replace the Site Controller card.
Activating Diagnostics
During repeater boot up, the option of aborting the boot process is indicated as it counts down on the EIC
display. Press and release the rotary knob during the countdown to abort the bootup process and activate
diagnostics. Once the boot up process is aborted, the Personality Menu is activated. Navigation through
the list of available personalities is performed by rotating the input control. If there exists only a single
personality, rotating the knob will appear to have no effect. Once the desired personality is displayed on
the front panel, pressing the input control knob will activate the currently selected personality.
.1.1 Navigation
Navigation is performed using the input control knob. All menu navigation is performed by both rotating
the front panel control knob and by depressing and releasing it. The act of depressing and releasing the
control knob is known as selecting. Rotating the knob clockwise is known as advancing or moving
forward, while rotating the knob counter clockwise is known as moving backward.
.1.1 LEDs
The LEDs on the EIC card indicate the following: (LEDs are numbered 1-5 from top to bottom.)
Note LED indications described here (see ) apply only during diagnostics mode (i.e., not
during normal operation).