Service manual

2000 SERIES RECEIVER DECODER MODULE (RDM)
3-9
March 2000
Part No. 001-3139-502
Select Repeater
Select the repeater number to be programmed or
edited from the pop-up menu (see Figure 3-10). Move
the cursor with the arrow keys to highlight the repeater
number and press Enter.
Figure 3-10 REPEATER LIST
Repeater Type Selection
This screen (see Figure 3-11) selects the repeater
type (Multi-Net signaling protocol and features):
Frequency Band 800 MHz
800 MHz [-12.5 kHz]
900 MHz
Power Level 75W
IAC Type 4 I/O IAC
Figure 3-11 REPEATER TYPE SELECTION
Delete Repeater
Figure 3-12 DELETE REPEATER
3.10.4 TRANSFER
Figure 3-13 TRANSFER MENU
Write Setup Parameters
This command sends the contents of a file to the
repeater and programs the EEPROM memory in the
Main Processor Card (MPC).
Figure 3-14 WRITE SETUP PARAMETERS
Figure 3-15 PROGRAM WRITE SETUP
Read Setup Parameters
This command reads the contents of the
EEPROM memory of a repeater and loads it into a
buffer. The contents of the buffer is then displayed to
show the programming of the repeater.
Figure 3-16 READ SETUP PARAMETERS
Figure 3-17 READING SETUP
Repeater List
default
Rptr 1
-------
-------
-------
Rptr 30
Select Rptr To Delete
Rptr 1
Program Rptr 1
Ok Cancel
Programming Setup Parameters
Count = 1
Ok Cancel
Read Setup Parms?
Reading Setup Parameters
Attempting access to Repeater