Service manual

2000 SERIES RECEIVER DECODER MODULE (RDM)
3-7
March 2000
Part No. 001-3139-502
3.10.3 EDIT
Figure 3-8 EDIT MENU
This menu is used to create new files and set or
change the RDM operating parameters. The filename
for the RDMs in this file is shown in the lower left
corner of the screen.
RDM Setup Parameters
This programs the RDM parameters and options
of each RDM at a Site. The following paragraphs
explain the parameters that are set by this screen (see
Figure 3-9) and give a brief description of each.
NOTE: The parameters are shown in the lower left of
the pop-up screen for reference.
Repeater Number
Each RDM is programmed with a repeater num-
ber from 1-30 for Multi-Net or 1-20 for LTR. Number
selection can be arbitrary as long as each RDM is
assigned a different number. However, make sure that
this number agrees with the Home repeater number
programmed in the mobiles assigned to that Home
repeater and also with the repeater number assigned in
the Channel Interface Module (CIM) in the Switch.
Channel Number
Each RDM is programmed with a number of the
channel that it is operating on (1-399 900 MHz
Systems or 1-920 800 MHz Systems). If the operating
frequency of a RDM is changed, this channel number
must also be changed.
Figure 3-9 RDM REPEATER SETUP PARAMETERS SCREEN