Service manual

2000 SERIES RECEIVER DECODER MODULE (RDM)
3-6
March 2000
Part No. 001-3139-502
Save
This saves the edited version of an existing file
loaded in the buffer under the same filename in the
directory and deletes the old file. Loads a new file
created in the Edit menu into the directory.
Save As
Use Save As to edited version of an existing file
loaded in the buffer under a new filename or give a
new file created in the Edit menu a filename.
Figure 3-6 SAVE FILE
Print Repeater Configuration
Select the destination for the configurations.
Printer - Prints to printer connected to PC.
File - Writes printable test to selected filename.
Select which RDM data will be printed.
All RDMs - Prints the data for all valid RDMs.
Single RDM - Print the data for the entered
RDM number.
NOTE: A list of valid RDMs can be seen under the
Edit-Select Repeater menu selection.
DOS Shell
Temporarily suspends the program and returns to
DOS. Directories and other DOS commands can be
performed. To return to the program from DOS, type
EXIT and press Enter.
Quit (ALT X)
Quit exits the RDM program and returns to DOS.
Be sure all files are saved before exiting the program.
Dir c:\example\file\load
..\
tmp\
Ok Cancel
Save File
File *.qx
test.qx
Figure 3-7 EDIT PROGRAMMING FLOWCHART
Repeater Number
Channel Number
System Key
System Priority Type
Voter Baud Rate
Test Mode ID
Default
Repeater Number
Select Repeater
EDIT
Setup Parameters F4
TELCO Network Type
Delete Repeater
Repeater Type
Multi-Net
LTR
Universal Station
Frequency Band
Power Level
75W
800 MHz
800 MHz (-12.5 kHz)
900 MHz
Repeater Type
IAC Type
8 I/O IAC
Revert Operation
Signal Strength Boundary Indexes
RDM