Service manual

2000 SERIES RECEIVER DECODER MODULE (RDM)
3-5
March 2000
Part No. 001-3139-502
3.7 2000 RDM PROGRAMMER
When the program is loaded into the computer
and executed, the menu shows the files available from
the directory. The program is used to Create, Edit,
Transfer and Receive the repeater and channel parame-
ters described in Section 3.10.8.
I M P O R T A N T
The commands and displays referred to in this Section
are for the IBM PC and may differ from IBM compati-
ble. Refer to the computer’s operating system manual
for command explanations.
3.8 ALIGNMENT SOFTWARE
The software for the RDM programs the Interface
Board to open and close the audio/data gates necessary
for the alignment selected from the Test-Full Repeater
menu. Under the menu heading Test are the alignment
procedures for the 800 MHz Receiver (see Section
3.11), 900 MHz Receiver (see Section 3.12) and over-
all Full RDM (see Section 3.13) including the Inter-
face Board (see Figure 3-3).
Refer to Section 3.11 for Alignment Procedures
as shown in the program, alignment points diagrams
and test setup diagrams.
Figure 3-3 RDM TEST MENU
3.9 HELP F1
Help screens are available for most parameters
and options in this program. Whenever a parameter or
options clarification is needed, press F1 and if a help
screen is available it will pop-up on the screen. Press
Escape <ESC> to exit the pop-up screen.
3.10 PULL DOWN MENUS
3.10.1 MENU DISPLAYS
The menus available are listed at the top of the
screen. Move the cursor with the arrow keys to high-
light the menu name. Press Enter to view the menu
and the arrow keys to scroll through the menu. Call up
the highlighted selection by pressing Enter.
3.10.2 FILE MENU
This menu manipulates new or existing files into
directories and saves files to be called up at another
time.
Figure 3-4 FILE MENU
Load
Load reads information from a stored file. The
program requests the filename to be loaded into the
buffer. The filename from a disk can be entered in the
highlighted area. Then move the cursor down with the
arrow key and highlight “Ok” and press Enter. To
select an existing file, use the arrow keys to move
down the menu list and press Enter when the high-
lighted filename is the file to load.
Figure 3-5 LOAD FILE
Dir c:\example\file\load
..\
tmp\
Load File
Ok Cancel
File *.qx
file1.qx