Operator`s manual
TROUBLESHOOTING
6-2
June 1997
Part No. 002-0690-201
Ping Options: Customize pings by selecting Options
in the Ping window menu. If Continuous Operation is
unselected (default), selecting Start ping will ping the
device once. If Continuous Operation is selected,
selecting Start ping will repeatedly ping the device
until Stop ping is selected. Ping time out is set in milli-
seconds and defines the amount of time OpenView
will wait for a response from the pinged device.
6.2 E.F. JOHNSON ALARMS
6.2.1 REPEATER GENERATED ALARMS
* Consoles will not receive audio from the affected channel. The channel will still be operating, unless it was shut
down by an automatic channel revert.
6.2.2 SITE/CHANNEL COMPUTER GENERATED ALARMS
Repeater in Test Mode IAC Input 1
IAC Input 2 IAC Input 3
IAC Input 4 Reserved (5)
Reserved (6) Reserved (7)
Reserved (8) MAC Processor
HSDB Processor IRDB Cable
RNT/CIM Channel Problem* TIC Processor
SMC Processor VNC
AC Power Fail Battery Power Fail
Power Supply Thermal Fan 1 Current
Fan 2 Current IAC Mismatch
GPS 1 PPS SMC Link
No A/D Samples GPS 10 MHz
Repeater in Setup State RF Shutdown (several modes)
RF Half Power Mode Thermal Sense in RF Portion
RF Finals 1 and 2 RF Finals 3 and 4
RF VSWR Normal Synthesizer Tx Lock
Normal Synthesizer Rx Lock HS Synthesizer Tx Lock
HS Synthesizer Rx Lock RF Quarter Power
Repeater Disabled
SCS in Test Mode SIB Link Alarm
Simulcast Failure Repeater Failure
Site Reverted Unable to Configure Repeater
Unconfigured Repeater