Quick Start Guide

Include and Assemble the Aeon Labs Door / Window Sensor – Quick install Guide

www.e-domotica.com 1

Include and Assemble the Aeon Labs Door / Window Sensor

This manual will help you to include and assemble the Aeon Labs Door / Window Sensor. After you have walked through this guide you

will be able to use the door sensor in a variety of scenes, scenarios and alarm settings.

1. Logging in to your e-Centre

 Start your computer or notebook.

 Open a browser, for example Chrome or Firefox.

 Open the e-Centre webpage via http://ecentre. Or go to the IP address of

the e-Centre, for example http://192.168.1.100.

 Log in with the standard PIN code 1234, or use your own PIN code.

2. Add the Aeon Labs Door Sensor to your e-Centre

If your home is fitted with several e-Domotica accessories (mains powered Z-

wave devices: it is recommended to include the door sensor at the place where

you will assemble it. Notice that you check the box named ‘Normal/High power’.

Also this only works when you already use a Z-Wave network.

At first we will include the Door Sensor to your e-Centre. Please follow the

steps below to proceed:

 Remove the plastic between the batteries and the door sensor. You can

open the door sensor by pressing the Latch Button. In the picture on the

left you can find where the Latch Button is placed. When finished, don’t

close the door sensor

 On the webpage go to ‘e-Domotica Products’

 At the right down corner click ‘Include’

 Press the Z-Wave button once. You can find the button next to the

batteries

 Wait patiently while the e-Centre will include the door sensor. When

finished name the sensor, choose a location and assign an icon. Next click

‘Save’.

3. Assemble the door sensor

Now that the door sensor is connected to the e-Centre, we can assemble it.

There are two possibilities to mount. You can screw or stick it. Although

screwing is recommended more, both possibilities are agreeable. If you decide

to screw it, the door sensor will be less delicate to be sabotaged.

In the picture on the left you will see how to assemble the door sensor in both

ways.

Please notice that the Orientation Dimples must be pointed to each other (see

picture below). Also it’s recommended to keep both the door sensor and the

magnet within a 2cm range.

Now the door sensor is ready to use. You can add the door sensor to a variety

of scenes, scenarios and alarm settings.

Visit our website for more manuals, instructions, examples and installation videos.