User's Manual

work .
9）、Once the controller connect with the receiver normally ，you
need not connect them by youself but just turn on
the power switch then they will connect
automatically later .
ATTENTION
1.Please comply with the polarity when install the batteries in the battery
case,and please make sure donot mix different-brand baterries toghther
when using .
2、 Set the power switch to “OFF”status to avoid consume the power
capacity .
3、 Please change fresh batteries immediately when the voltage is low.
4、 In order to avoid battery’s leak and the damage to the inner circuit
Take out of the batteries from the battery case when will not use in
long time .
5、 Please donot take apart the product personally.
6、 The final explanation right of the instructaion manual belongs to E.
CORE TECHNOLOGY (CHINA ) CORPORATION LTD.
Remark:
Section 15.21 Information to user
The users manual or instruction manual for an intentional or unintentional radiator shall
caution the user that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.Modify the statement that will be placed in the User Manual to be the
following wording:
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT.SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO
OPERATE THE EQUIPMENT.
Section 15.105 Information to user
(a) For Class A digital device or peripheral, the instructions furnished the user shall
include the following or similar statement, placed in a prominent location in the
text of the manual:
NOTE:
This equipment has been tested and found to comply with limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
(b) For Class B digital device or peripheral, the instructions furnished the user shall
include the following or similar statement, placed in a prominent location in the
text of the manual:
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.