User's Manual

Product declaration :
Product function declaration ：
10、 Using illustration
1）、Open the battery cover，install the 1.5V 3 AAA batteries in the
battery case comply with the polarity ，then close the
battery cover .
2）、Connect the GameCube with Televison Set ,put into game
disk,then insert the receiver.
3）Set the switch which is at the back of the controller to “ON”
to turm on the power，POWER LED flash ，then turn on the
power switch of the console，the “CONNECT LED”of the
receiver flash；If then the LED of the controller and receiver
turn flash to shine steadily ，which means the connection
between the controller and receiver is normal and can be
operated normally ；if the LED continue flashing that means
the controller did not connect with the receiver.
4）、Press the key “CONNECT”on receiver ，the flash velocity
speed up ，then press the key“CONNECT”on the
controller until the “CONNECT LED” of the
receiver shine steadily，when the connection between
the controller and receiver is normal.
5）、After connection keeps nornal ,if without pressing any
buttons in 5 minutes，the controller will enter into sleeping
saving electricity mode automatically .Just need pressing the
key “CONNECT”of the controlelr when using ,the fuction
will be waken in three seconds ，and the POWER LED shine
then recover the nornal work status .
6）、When thecapacity of battery power if too low the POWER
LED will flash incessantly to remind you changing the fresh
batteries in time.
7）、Press any function keys ，then press the key “TURBO”；
pressing the key by seted up ,then pressing “TURBO”
again will cancel TURBO function；Press the“TURBO”key，
then press the“START” key again to choose the velocity of
the TURBO，there are four kinds of velocity selection in
all ，once press it will change to another velocity.
8）、When the controlelr’s range beyond the receiving range ,the
key “CONNECT LED” of the reveiver will continue
flashing ,then the controller will not work normally or cannot