Users Manual

Occasionally, it is necessary to pair/sync a transmitter to a collar
receiver, the following procedure will accomplish this.
1. Turn on the Transmitter
2. Set the stimulation level at “0”
3. Make sure Receiver is turned off.
4. Press the Collar Receiver’s Power-Button for more than 5 seconds until
green light on receiver flashes rapidly.
5. Immediately after, press and hold -button followed by the -button
until you hear confirmation sound from collar receiver.
HOW TO CHANGE THE TRANSMITTER TO A 2 DOG TRANSMITTER
The button functions will change. The changes are described on on pages 26
through 41. You can change the transmitter back to the 1Dog system (560)
at any time.
1. Turn on the Transmitter.
2. Set the stimulation level at “0”
3. Press the -Button followed by the -Button simultaneously for
more than 2 seconds until you hear the confirmation beeps.
4. Repeat step 2 to return back to a 1 dog system.
ADD/REPLACE COLLAR FOR SECOND DOG
1. Turn on the Transmitter
2. Set the stimulation level at "0" when 2D is displayed on the LCD.
3. Make sure Receiver is turned off.
4. Press the Collar Receiver’s Power-Button for more than 5 seconds until
green light on receiver flashes rapidly.
5. Immediately after, press and hold -button followed by the -button
until you hear confirmation sound from collar receiver.
REPLACE/ADD COLLAR
25
FE-560A/562A Owner’s Manual