Data Sheet

-14-
Advanced Troubleshooting (adult supervision recommended)
E-Blox
®
is not responsible for parts damaged due to
incorrect wiring.
If you suspect you have damaged parts, you can
follow this procedure to systematically determine
which ones need replacing:
1. Lamp (76), LEDs (69, 70, 71), Battery Holder
(91): Place part directly across the battery holder as
shown, it should light. If none
work, then replace your batteries
and repeat, if still bad then the
battery holder is damaged. Make
sure the LEDs are installed in the
correct direction.
2. Wire Blocks (1-5), Spring Wire (9), and Speaker
(95): Use this mini-circuit to test each of the Wire Blocks
and Speaker (95), one at a time. The lamp (76) should light
if the part is functioning properly. Follow the steps below:
Spring Wire test - Build the circuit shown
below. The lamp (76) should light.
Wire Block tests - Insert the Wire
Blocks between the spring wire to
lamp connection shown in the gure.
The lamp should light.
Speaker test - Insert the speaker (95) between the spring
wire to lamp connection shown in the gure. The
speaker will not sound, but the lamp will light.
3. Alarm (78): Place the alarm across the
battery holder as shown. The alarm should
sound.
4. Switch (62), Press switch (61), Reed Switch
(83):
Use this circuit to test each switch. The lamp (76)
should light. If the lamp doesn’t light, then the switch is bad.
Switch - Up position the lamp off, Down position lamp on.
Press - Light when switch is pressed.
Reed - When you place the
magnet on the switch the
lamp should light.
5. Generator (99) & Hand Crank (94): Build the circuit
shown below. The lamp (76) should light when the hand
crank is turned.
E-Blox
®
880 Asbury Dr., Buffalo Grove, IL 60089 U.S.A.
Phone / Fax: (855) MY EBLOX (693-2569)
e-mail: [e-mail] l Website: www.myeblox.com
You may order additional / replacement parts at:
www.pickabrick.com