Manual

-14-
Advanced Troubleshooting (adult supervision recommended)
E-Blox
®
is not responsible for parts damaged due to
incorrect wiring.
If you suspect you have damaged parts, you can
follow this procedure to systematically determine
which ones need replacing:
1. Lamp (76), LED (69), Colorful LED (72): Place part
directly across the battery holder as shown; it should light.
Make sure the LEDs are installed in the correct direction.
If they do not light, then replace your batteries and repeat.
If they still fail to light, then the battery holder is damaged.
2. Bi-directional LED (71): Place the LED across the
battery holder; it should light in both directions.
3. Motor (95): Place the motor across
the battery holder (95 at top) as
shown; it should spin clockwise.
4. Switch (62), Press switch (61), Reed Switch
(83): Use the circuit below to test each switch. The lamp
(76) should light. If the lamp doesn’t light, then the switch is
bad.
Switch - Up position the lamp off, Down position lamp on.
Press - Light when switch is pressed.
Reed - When you place the magnet on the switch the
lamp should light.
E-Blox
®
880 Asbury Dr., Buffalo Grove, IL 60089 U.S.A.
Phone / Fax: (855) MY EBLOX (693-2569)
e-mail: [e-mail] l Website: www.myeblox.com
You may order additional / replacement parts at:
www.pickabrick.com
Red Blue