664WC WiFi-6 Wireless Router Quick Start Guide 1
01 Product Overview Thank you for choosing our product. Please read this manual before use. Product Mode:1664WC as single router 1664WC is an AP without Mesh function by default.Please refer to SINGLE ROUTER SETUP STEPS for network setup. Product Mode:1664WC-DUO as mesh router set 1664WC-DUO contains two APs(Main AP and satellite AP) distinguished by the label on the backside of the device. Please refer to SINGLE ROUTER SETUP STEPS (for Main AP) & MESH SETUP STEPS (for Satellite AP) for network setup.
02 Product Hardware Description Product Appearance Description Button Description Button WPS Function Set the WPS process. Short press (1 second) for reset the router; Reset Long press (5 seconds or longer) for reset to factory default settings. * Operate after the LED is Blinking Green/Steady Green. ON/OFF Power on and off the router.
03 SINGLE ROUTER SETUP STEPS The DZS Router can be connected according to the diagram above. 01 Note the DSL/PON/Cable Gateway must be connected to the WAN port of DZS Router. When it is connected to the Internet ,the LED light is steady green. If you can, place the DZS Router in an open area such as a table or a shelf. 02 Wired devices can be connected directly to LAN port for Internet access.
Option 1: Wireless Networking 01 Main AP refers to SINGLE ROUTER SETUP STEPS to complete the connection. 02 Place the Satellite AP at a proper location based on your home layout. 03 Just power on the Satellite AP and wait for about 5 minutes.When the LED is Steady Green, then the Mesh networking is successful. Tip: To optimize wireless performance, place the Satellite AP in a location that minimizes the barrier (such as wall, door, and floor) between the Main AP and Satellite AP.
Option 2: Wired Networking 01 Main AP refers to SINGLE ROUTER SETUP STEPS to complete the connection. 02 Place the Satellite AP at a proper location based on the cable deployment in your home. 03 Connect the Satellite AP to LAN port of your Main AP via network cable. 04 Power on the Satellite AP. When the LED is Steady Green, then the Mesh networking is successful.
*Note: (1) If you know there is a spot in your home, where the Wi-Fi signal is the weakest. Try place the Satellite AP midway between the Main AP and the weakest spot. (2) When Main AP and Satellite AP pairing successfully, the SSID and Password would be same, that is showing on the backside of Main AP. 05 Management Methods Option 1:HTTP 01 Connect your device to the Router using wireless or wired connection. 02 Open an Internet browser and enter http://192.168.0.1(or http://azoresrouter.com).
06 Frequently Asked Questions Q1 Internet is not accessable. Answer: (1) If the LED of 1664WCor Main AP in 1664WC-DUO mesh set keeps Blinking Red,check whether its WAN port is connected to your Broadband Gateway (i.e. DSL/Cable modem, PON gateway) with a network cable. (2) If the LED of 1664WC or Main AP in 1664WC-DUO mesh set keeps Blinking Green,check whether its WAN settings is all right or your Broadband Gateway service is all right.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
