User Guide

8 01Optional settings
Adjust your programme
Use these options to adjust the
default settings of the wash
programmes. On certain
programmes some temperature,
spin and soil level settings cannot
be overridden in order to protect
your clothes; see programme table
section 9 01.
To personalise the default wash programmes
1
Start delay
This option allows you to delay
the start of the cycle by up to 24
hours. Use the and arrows
to adjust the settings. The display
will show the delay time to start.
Press the ‘start’ button to initiate
the countdown. Press the ‘cancel’
button at any time to cancel.
The soap tray should be
completely dry before adding the
detergent. Only available on
CRO1 Memory.
Memory buttons
This option allows you to store
three of your favourite
programmes. Once you have
selected your desired
programmes and options, press
and hold one of the memory
buttons for three seconds.
A beep will confirm the
programme has been stored.
To select a stored programme,
press the correct memory button
and then start the cycle.
To override a stored programme,
follow the steps detailed above.
Only available on CRO1 Memory.
Door lock
The door lock light indicates
that the outer door is locked.
When a programme is paused
the door will unlock if it is safe
to do so. If not, the display will
indicate why the door stays
locked. Press the ‘start’ button
to finish the programme.
Child lock
This option locks the settings
on the control panel and locks
the outer door. Before the
programme is started use this
option to prevent the settings
from being altered or the
programme being
inadvertently started. Once a
programme is running use this
option to prevent it being
paused or cancelled.
Press and hold the ‘minimum
iron’ button to activate and
cancel the child lock option.
Add options
To activate any of the options
below after you have selected
your programme, press the
desired option button once; press
again to cancel the option.
Minimum iron
This option holds your clothes in
water after the final rinse to
minimise creasing.
The machine will pause and the
‘start’ button will flash.
Press the ‘start’ button to finish
the cycle. To protect your clothes,
this option is not available on all
programmes.
Pre-wash
This option will remove excess dirt
before the main wash cycle.
Extra rinse
This option adds one extra rinse
(for people with sensitive skin).
Rinse & spin/Spin only
Press once for rinse & spin, press
twice for spin only.
Press again to cancel.
Soil level selection guidelines
Dirt
Select ‘Dirt’ for garments which
are only lightly soiled
(see programme table for
maximum load).
Dirt & stains
Select ‘Dirt & stains’ for typical
everday soiling.
Heavy stains
Select ‘Heavy stains’ for an even
more thorough programme to
remove those rare, heavy stains.
2
3
4
6
5