User Guide

European conformity information
This product has been tested and found to be in conformity
with the following European Directives:
73/23/EEC Low Voltage (safety) Directive.
93/68/EEC CE Marking Directive.
89/336/EEC EMC Directive.
When all of the instructions on the previous pages have been
completed, the machine can be installed into its operating
position using the Rollerjack
TM
handle, see section 4 01.
Using the Dyson spanner, adjust the two front feet so that the
machine is perfectly stable and level and will not rock on
three of its four floor contact points.
Do not use wood, carpet or other material to stabilise
the machine.
5 03Installation
•
•
•
•
•
•
•
•
•
•
Cold only water supply
If there is no hot water supply, attach the cold and hot pipes
to the machine as normal. Then, attach both hoses to a Y
piece connector (available as a separate accessory, see rear
page for Helpline telephone number) and finally connect the
Y connector to the cold inlet tap.
Once all connections have been made, turn on the tap(s) to
check that there are no leaks.
Electrical installation
Warning: This appliance must be earthed
Any electrical work required to install the washing machine
should be carried out by a Dyson trained installer or
qualified electrician.
Before using your machine, check that the plug and sockets
match, and check that the voltage in your home corresponds
to that indicated on the rating plate.
For the rating plate's location, see section 101.
The machine should be plugged into a switchable, earthed
socket that is easily accessible after installation.
Do not use an extension cord or plug adapter.
If the supply cord or plug is damaged disconnect the
appliance from the socket outlet immediately. The supply cord
must only be replaced by Dyson or its appointed agent, as
special purpose tools and service techniques are required.
If the plug supplied needs replacing it should be cut off and
safely disposed of. Under no circumstances should the
severed plug be inserted into a socket outlet as this may result
in an electric shock hazard.
Always:
connect your machine to the water supply by hand, using the
hoses supplied. Do not use old hoses.
the water pressure should be between 0.4 and 5 bar.
Do not tighten the plastic hose connections with a spanner.
Do not connect to a mixer tap.
Hot and cold water supply
Attach the blue hose to the cold inlet tap and the red hose to
the hot inlet tap.
Water supply
Drainage
5 02
Installation
•
•
•
•
•
•
•
•
•
Drainage hose hook
Drainage hose
You can alter the direction of the drainage hose to the left or
to the right.
To change the direction of the machine’s drainage hose,
open the retaining clip using a pair of pliers, and hold it open
while you rotate the hose.
Ensure the hose is inserted fully before releasing the clip.
Thread the drainage hose through the hose hook and adjust
the protruding end to a distance of 30mm. The hose hook
has a small retention hole that can be used to secure the
hose assembly in position.
Do not use hose hook for under sink connections.
When installed into a standpipe or under sink connection,
ensure that the water outlet end of the drainage hose is no
lower than 450mm from ground level. Position the hose so
that at no point in its entire length it lies above 600mm from
ground level, refer to image in section 5 01.
Failure to comply with these dimensions could cause the
machine to malfunction.
30mm
Stand pipe