User Guide

To access the rear of the machine use the Rollerjack
TM
handle;
see section
Cleaning the water inlet filters
The water inlet filters should be checked regularly for debris or
limescale build-up, (depending on whether the water in your
area is hard or soft). Contact your local water authority to find
out your water composition.
Turn off the water supply to the machine.
Unscrew both water inlet pipes by hand.
Using pliers, pull out the filters and rinse under cold water.
Replace filters and reconnect water inlet pipes.
Water filter maintenance
Emergency door release
10 03
This procedure should be used in the event of a power cut
to remove clothes.
Switch off and remove the plug from the socket.
Ensure the drums have stopped moving.
If the machine has been running a hot wash, leave it to
cool down.
Completely drain the washing machine as described in the
‘Coin trap maintenance’ section, section
Remove the soap tray as described in section
Using the Dyson spanner, turn the door release screw
anticlockwise to unlock the door.
Open the outer and inner doors.
Turn the door release screw clockwise through a quarter of a
turn, to ensure the door will close.
Replace the soap tray.
Maintenance
•
•
•
•
•
•
•
•
•
•
•
•
•
4 01.
10 01.
10 02.
11 01Troubleshooting
LCD display is blank
Machine displays
“Overload reduced
performance”
Machine displays
“Close inner door then
press start”
Certain spin speeds, temperatures,
dirt levels cannot be selected
Cancel button does not
work during a wash
Cannot open door
Washing machine leaks
water
Washing machine shakes
during the cycle
Machine displays
“Close outer door then
press start”
Machine displays
“Not emptying: check hose
and coin trap”
Machine displays
“Not filling: check water supply”
Machine displays
“Uneven load cannot spin”
Before calling the helpline, please read carefully the following pages.