Operation Manual

Inner transit packaging removal

Before installation

8 Remove the four screws securing the bracket to the machine

casing and lift out the transit bracket.

• Refit the lid and two screws.

To replace the packaging (eg: for moving house), reverse the

procedure described above.

Please retain the transit packaging for future use, as it

should be used whenever the machine is relocated.

Moving the Contrarotator

• To move the machine, pull out the Rollerjack

handle from

underneath the machine, which will enable you to manoeuvre

the machine easily into your desired position.

• Replace the Rollerjack

slowly because the handle may return

with force.

NB: The Rollerjack

is designed for final positioning only and

not suitable over long distances. Do not push with your foot.

4 01

Before installation, check the machine for damage.

A qualified person should always carry out installation.

All packaging must be removed before the machine is

connected to power or water supplies.

1 Open the outer door and carefully lift out the foam inserts

from the front of the inner door.

2 Take off the rear panel by removing the seven screws, using

a cross-head screwdriver.

3 Carefully withdraw the foam block and then refit the rear

panel and screws.

4 Remove the two screws from the rear of the lid.

5 Remove the lid by sliding it backwards and upwards.

6 Remove the plug inserted into the transit bracket from inside

the machine.

7 Using the Dyson spanner remove the four bolts securing the

top transit bracket.