Installation Guide Free 5 year guarantee Register your guarantee at www.dysonairblade.
Important safety instructions LOCATION • • Read before proceeding further. Retain for future use. • • Warning All electrical installation and repair work should be carried out by a qualified electrician or Dyson Service Engineer in accordance with current local codes or regulations. Important • Warning Risk of electric shock! If casing is removed or handled improperly the internal components of the unit may cause harm or become permanently damaged.
2 1 Contents Unpacking. Positioning. 24mm To top of fascia REAR VIEW Side cable entry Side cable entry 211mm Rear cable entry Hand dryer Back plate Recommended height measurements are from the floor. 1300mm adult male 1265mm adult female 1269mm wheelchair user 928mm childer 5-8 years old 1028mm childern 8-11 years old 1105mm children 11-14 years old Service tool x1 Side bracket and seal assembly x1 Main body Caution Before installation decide if the cable entry is to be from (3.
3.1 Rear cable entry. 6mm ● Primary fixing locations (x4). ● Primary fixing locations (x4). Do not use countersunk screws. Fixing the backplate to the wall. Fit the backplate securely to the wall using the appropriate fixings for the wall type and weight of the unit. Do not use counter-sunk screws. Do not secure tightly until after the power cable has been secured. 4. Mark the location on the wall with a pencil. Use the backplate to mark the locations for the four fixing points. 5.
3.2 Side cable entry. Left 6mm Right ● Primary fixing locations (x4). REAR VIEW REAR VIEW Do not use countersunk screws. ● 5th hole for side entry Important Cable entry can be either from the left or the right. Decide which before you start. The unit is designed to have only one side cable entry point. NOTE: If the side entry option is chosen, a 5th hole will need to be drilled in the wall. Make sure you work on the correct side for the installation.
4 5 Connecting to terminal block. Attaching main body. 6mm L N Warning: Risk of electric shock! Ensure power is not connected. 1. Ensure the cable does not sit above the cable guide from the cable inlet to the terminal block. If the cable sits above the guide walls it may interfere with main components, prevent the security screws being fitted correctly, or risk the main body being forced on to the backplate, causing damage. 2. Unscrew the cable clamp from the backplate.
JN.48486 PN.60251-03-01 17.10.12 Dyson Customer Care Helpline www.dysonairblade.com UK 0800 345 7788 ROI 01 401 8300.
