Technical Specifications

Product range
AB09 Short AB10 Long AB11 Wall
Electrical
Input voltage/Frequency: 220-253V 50 Hz
Rated power: 1600 W
Motor type: Dyson digital motor – brushless DC Motor
Motor switching rate: 6,000 per second
Motor speed: 90,000 rpm
Operating temperature range: 0° – 40°C
Heater type: None
Standby power consumption: Less than 0.5 W
Construction
Tap construction: Stainless steel (brushed)
Under counter motor assembly construction: Moulded ABS (main unit)
Exterior screw type: Torx T15
Water ingress protection to IP35
Filter
HEPA filter (glass fibre and fleece prelayer)
Bacteria removal 99.9%
Operation
Touch-free infra-red activation
Hand dry time measurement: 12 seconds (Measurement based
on National Sanitation Foundation Protocol P.335)
Operation lock-out period: 30 seconds
Airspeed at apertures: 430 mph
Operating airflow: Up to 30 l/s
Maximum altitude: 2,000 metres
Water operation
Water flow rate: 4 l/min
Tap Aerator: Aerated water outlet
Tap power supply: Mains supply
Water temperature control: Thermostatic mixer recommended (not supplied)
Water pressure required: 1-8 Bar
Logistics
Serial number prefix: AB09 EC1; AB10 EC2; AB11 EC3
Single unit order code: AB09 25818-01; AB10 25819-01; AB11 25820-01
Net weight: AB09 4.3kg; AB10 4.6kg; AB11 9.0kg
Packaged weight: AB09 5.7kg; AB10 6.1kg; AB11 11.4kg
Packaged dimensions: AB09 H303 × W284 × D286 mm
AB10 H276 × W437 × D280 mm; AB11 H302 × W610 × D375 mm
Unit barcode: AB09 5025 1550 1577 3;
AB10 5025 1550 1578 0; AB11 5025 1550 1579 7
Sink specification
The Dyson Airblade Tap hand dryer is compatible with most sink types.
Ensure plugs are not installed in the sinks.
Sink dimensions: All sink measurements are internal unless stated otherwise.
Width of sink – Minimum: 350mm, Front to back – Minimum: 300mm
Depth of sink – Minimum: 100mm
Maximum depth of sink for AB10 only: 200mm (External measurement
of vessel sink).
Sink materials: Sinks with highly polished surfaces should be avoided e.g.
reflective chrome. Porcelain or brushed metal are ideal. When multiple taps
are installed side-by-side, tap centres should be a minimum of 580mm apart.
Standard guarantee
5 year guarantee
For further information please contact Dyson.
0800 345 7788 (UK) 01-401-8300 (IE)
www.dysonairblade.com
The NSF logo is a registered trade mark of NSF International.
The Carbon Reduction Label is the registered trade mark of the Carbon Trust.
HACCP International non-food certification mark is the registered trademark of
HACCP International. HACCP International have certified Dyson products based
on their recommended installation and operating conditions. Licensed by Dyson.