Use and Care Manual

Getting started

1 2 3

Unscrew the cap and fill the tank to the

top. Replace the cap and screw until

hand tight. Carry by the handle.

Place the tank on top of the base.

Ensure the base is on a level surface,

otherwise the machine will not operate.

Place the loop amplifier on top of the

tank. Push down until you hear a click.

Remote control docks magnetically.

Attach the remote control to the top

of the machine with the buttons

facing down.

For the best performance place humidifier on the floor

in the corner of the room, facing into the center. It should

be at least 3.2ft from any wall. To avoid a cooling effect

while humidifying, the unit should be at least 3.2ft from

any people. Consider placing near to air conditioning or

heating devices to circulate air effectively.

4 5 6

Plug into the socket and base. A small

blue LED on the back of the appliance

lights up to confirm that the machine

has power.

Switch ‘ON’. The water treatment

procedure automatically starts.

Water passes over a UV-C emitter to

ensure that it is 99.9% bacteria-free

before misting commences. This takes

approximately 3 minutes. (During this

time humidity targets can be set and

fan mode can be switched ON’.)

After 3 minutes the machine will start

to humidify. The display will show the

target humidity setting.