Owner's manual

EN
CTF-1210
CTF-1210
8 9
Making coee
1. Fill the coee pot with fresh, cold water. Open the lid at the top of the water tank and use the pot to ll the
tank.
Make sure the water level doesn’t exceed the MAX level.
2. You can either use the reusable lter or disposable lter paper (size 1x4) to make coee. When using lter
paper, remove the reusable lter from the holder. Form the lter paper into a funnel and place it carefully
inside the lter holder.
3. Put an appropriate amount of ground coee in the lter, then close the lid of the water tank.
4. Put the coee pot (with the lid closed) onto the hotplate.
5. Make sure the mains switch is o. Connect the appliance to the mains and switch it on. The red power light
will illuminate.
6. Hot water will start to ow into the lter after a short while.
7. Do not open the water tank lid when the coee maker is switched on. If you want to pour coee from the pot
before the ltering process is complete, simply remove the pot from the hotplate. The anti-drip mechanism
will stop coee from falling onto the hotplate. Make sure you replace the pot within 30 seconds. The ltering
process will resume automatically when you replace the coee pot.
8. Let all the water boil and lter through the ground coee into the pot before switching the appliance o. The
amount of coee produced will be slightly less than the amount of water you started with; this is because
some water evaporates and some is absorbed by the coee in the lter.
9. The hotplate will keep the coee pot at an appropriate temperature until the appliance is switched o. Coee
tastes best when it’s fresh, so don’t let it stand too long. Never let the coee pot dry out when it’s on the
hotplate.
Attention! Never leave the appliance connected to the mains when it is unattended.
10. When you’ve nished using the coee maker, turn o the power and remove the plug from the mains socket.
Always turn the mains power o when the appliance isn’t being used. Allow at least ten minutes of cooling
time before making any more coee. Do not remove the lter or empty the coee grounds until the appliance
has cooled down.
MAIN COMPONENTS
1. Water tank lid
2. Water tank
3. Water level indicator
4. Heat-resistant glass coee pot
5. Hotplate
6. On/o switch
7. Filter holder
8. Anti-drip mechanism
9. Reusable lter (not shown)
10. Mains cable and plug (not shown)
POWER SUPPLY
The appliance must only be plugged into a mains electricity supply that provides 220-
240V~ at 50HZ and has a protective earth connection. Always make sure the voltage of
your mains supply matches the voltage indicated on the appliance.
USING OF APPLIANCE
Before using the appliance for the rst time:
1. Unpack the appliance and remove all the packing materials.
Never leave the nylon packing bag, which is part of the package, within the reach of children who could play
with it.
2. Carefully check the appliance to ensure it is complete and undamaged. You should only use the appliance if it
is complete and has not suered any damage.
3. Please clean the appliance before rst using it:
a) Use mild, soapy water to wash the glass coee pot and the reusable lter. Rinse them and wait until they
are completely dry before putting them back in the appliance.
b) Fill the water tank according to the instructions but do not put any coee in the lter. Let the appliance
heat the water, which will rinse all the internal parts.
c) After using the appliance with just water, switch it o. Empty the water from the coee pot, then wash the
pot and the lter again. Repeat the lling, heating and rinsing process for a second time. The coee maker is
now ready for regular use.