Operation Manual

DYON OMEGA 22 v2
25
EN
7.1.2 How to receive the DVB-S programs
Scan the satellites to receive the programs.
( 1) Press <DVB-S Setup> button to enter Main Menu.
( 2) Press <Left/Right> button to select SETUP option.
( 3) Press <Up/Down> button to select My Dish (Reception) option.
( 4) Press <OK> button to enter My Dish (Reception) page.
( 5) Press <Up/Down> button to select the preinstalled satellites.
( 6) Press <Red> button to scan both satellites if you are using ASTRA and HOTBIRD.
( 7) Press <Blue> button to scan only the selected satellite.
( 8) Press <Green> button delete the selected satellite.
( 9) Press <Yellow> button to delete all satellites.
(10) Press <OK> button to configure the settings of the selected satellite as below.
Satellite configuration
Satellite configuration and manager is in Main Menu->Setup->Installation->MY DISH menu.
Firstly, select the proper switcher according to the switcher you have, as Figure 1.
( -) Press <Red> button to add a satellite or to change the current one.
( -) Press <Green> button to edit the satellite name.
Figure 1.Satellite Installation Figure 2.Add Satellite
For sample switcher, each branch is connected with a satellite, user can configuration it as Figure 2.
For DiSEqC1.2 motor, user can set limit position, user location and LNB of it, as ,then user can adjust and
store max 32 position for different satellites, as Figure 3, Figure 4.
Switch Type: Select DiSEqC1.0/1.2 switcher or DiSEqC1.2 motor, or select none if you don't
have any DiSEqC device.
Toneburst: Enable or disable toneburst switcher. Move down to the satellite selection area,
and press OK key to add the proper satellite, as Figure 2.
LNB Type: Select the LNB type according to your dish.
LNB Low Freq: Set the low frequency of LNB.
LNB High Freq: Set the high frequency of LNB if it is universal.