Operation Manual

DYON OMEGA 22 v2
12
EN
4.4 Connecting to External AV Signal Source (HDMI)
Follow the figure below to connect an HDMI signal source to the HDMI jack on the rear panel of the
unit.
After connection, turn on the power of the unit and the external AV signal source and use the
SOURCE and the direction buttons to select HDMI mode, and then press the OK button to confirm.
HDMI provides both audio and video signals and typically provides superior image quality
to component, S-Video or composite.
4.5 Connecting a USB Devices (DVB-S Mode)
This unit is designed with a USB port, can be connected to the USB device, see the figure below:
If possible, please connect USB devices directly to the Devices USB interface.
If this is not possible, use only USB extension cables not exceeding 25 cm.
This USB port can only be accessed by using the DVB-S Setup menu. Please refer to chapter 8
Please note that only DVB-S programs can be recorded!
4.6 Connecting a USB Devices (DVB-T Mode)
This unit is designed with a USB port, can be connected to the USB device, see the figure below:
If possible, please connect USB devices directly to the Devices USB interface.
If this is not possible, use only USB extension cables not exceeding 25 cm.
This USB port can only be accessed by using the DVB-T Setup menu.
Please note that only DVB-S programs in DVB-S mode can be recorded!
Therefore you need to use the other USB port at the backside.