Installation Guide

SV-COM-760, SV-COM-T25 and SV-COM-T83 Installation and Configuration
SkyView System Installation Guide – Revision AK (draft) 16-5
• Secure the SV-COM-T25/T8 to the aircraft via the three (3) mounting holes in the plate. The
unit should be mounted to a flat surface – it is important that the tray is supported at the
dimples as well as the three mounting points.
• Put the SV-COM-T25/T8 into the secured mounting tray by hooking the connector end
under the lip on the tray.
• Lock the SV-COM-T25/T8 into the mounting tray by clipping the retaining wire over the lugs
on the opposite end.
• The SV-COM-760 is secured by four (4) mounting holes on the bottom plate.
Additional items you will require for installation of an SV-COM-XXX radio system, but which are
not in the packaging, include:
• Nutplates for mounting SV-COM-PANEL to the panel
• Circuit breaker or fuse for power to the SV-COM-T25/T8 and SV-COM-PANEL
• Power wires to transceiver module.
• Transceiver module to SV-COM-PANEL wiring.
• SkyView Network cables to connect the SV-COM-PANEL to SkyView Network
• COM Antenna, coaxial cable, terminated to TNC Male connector or cable and TNC Male
connector is included with your COM antenna. The SV-COM-X25/X83 are compatible with
aircraft COM antennas commonly available (may require a TNC Male to BNC Female
adapter).
• The SV-COM-760 is requires a more commonly found BNC connector.