Installation Guide

SV-COM-760, SV-COM-T25 and SV-COM-T83 Installation and Configuration
16-4 SkyView System Installation Guide – Revision AK
(draft)
Figure 209 – SV-COM-PANEL - VERTICAL Panel Cutout and Mounting Hole Dimensions - NOT ACTUAL SIZE
Physical Installation: SV-COM-XXX Transceivers
The figures on the following pages show mechanical dimensions for the SV-COM-760/T25/T83
remote transceiver modules.
The following installation procedure should be followed to install a remote transceiver module,
remembering to allow adequate space for installation of cables and connectors.
• If you are installing two transceivers, or combination thereof, it is acceptable to co-locate
the two transceiver modules.
• Select a position in the aircraft for the transceiver modules that is not too close to any high
external heat source and where reasonable airflow is available. The transceiver module is
not a significant heat source itself and does not need to be kept away from other devices
for this reason.
• Avoid sharp bends and placing the cables too near to the aircraft control cables.