Installation Guide User Manual

SV-EMS-220/221 Installation and Configuration

7-62 SkyView System Installation Guide - Revision S

When OIL TEMP is > 190° F, the OIL TEMP gauge will display different ranges:

 100-120 and 230-266° F in YELLOW

 120-230° F in GREEN

 266-280° F in RED

The alarm type for oil temperature is the “self-clearing” type.

EMS Sensor Definitions, Mapping, and Settings

All sensors must be defined, mapped to SV-EMS-220/221 pins, and have their

settings configured. This section describes how sensors are defined, mapped, and

set in SkyView.

EMS Sensor Definitions

All EMS sensor installations require a SkyView Sensor Definitions file. This file provides

characterizations of all sensors that SkyView supports, and is occasionally updated to add

additional supported sensors and correct issues with existing sensors. The most current version

of the SkyView Sensor Definitions file is preloaded onto each display prior to shipment. The

most current version of the SkyView Sensor Definitions file can be downloaded from

http://downloads.dynonavionics.com. If you have more than one SkyView display, and the

SkyView Sensor Definitions file on each display is different from one another, a warning

message will be displayed:

EMS SFG FILE MISMATCH.

If you need to update the SkyView Sensor Definitions file, download the file and use the

instructions found in the How to Load and Delete Files Section.

The SkyView Sensor Definitions file has a .sfg file extension. This file is not

automatically shared between displays. It must be loaded onto each display in the

system.

EMS Sensor Input Mapping

In order to save installers time, Dynon provides preconfigured sensor mapping and

settings files which support popular four and six-cylinder engine installations. All of

the installations mentioned in the Example Engine Sensor and Transducer

Installations Section have preconfigured mapping and settings files that are

available for download at http://downloads.dynonavionics.com.

Settings for SV-EMS-220/221 pin mapping, ranges, widget graphical properties,

etc. are automatically shared between multiple SkyView displays.

If your engine installation is listed in the Example Engine Sensor and Transducer Installations

Section, we recommend you install one of the sensor mapping and settings files onto the