Autopilot Servo Installation Guide RV9 Roll This product is not approved for installation in type certificated aircraft Document 101046-004, Revision G May, 2014 Copyright © 2009-2014 by Dynon Avionics, Inc.
DYNON AVIONICS Contact Information Dynon Avionics, Inc. 19825 141st Place NE Woodinville, WA 98072 Phone: (425) 402-0433 - 8:00 AM – 5:00 PM (Pacific Time) Monday – Friday Dynon Technical Support available 7:00 AM–4:00 PM (Pacific Time) Monday – Friday Email: support@dynonavionics.com Fax: (425) 984-1751 Dynon Avionics offers online sales, extensive support, and frequently updated information on its products via its Internet sites: www.dynonavionics.com –Dynon Avionics primary web site; including: docs.
DYNON AVIONICS SERVO MOUNTING INSTRUCTIONS – RV-9 RIGHT WING ROLL KIT Kit Contents Dynon Part # QTY Part Description 100836-000 2 Large Male Rod End 100870-001 1 RV7,8,9,10 Right Roll Bracket 100872-000 1 RV7,8,9,10 Right Support Bracket 100972-000 1 RV9 Attach Plate 100966-008 1 Aluminum Pushrod Tube - 3.
DYNON AVIONICS between it and the servo. Secure it to the upper bell crank support bracket using the existing fastener. Remove the necessary hardware in order to add the included linkage attach plate and 0.485" spacer using a combination of Dynon-supplied hardware, and existing hardware. With the servo and bell crank additions in place, torque all fasteners back to original installation specifications and add safety wire throughout. With the servo installed, the linkage needs to be assembled.
DYNON AVIONICS Wiring Overview The following diagram provides an overview of the autopilot-specific wiring installation. For the complete set of wiring and configuration instructions, please see the latest Installation Guide for your Dynon EFIS product. For a SkyView system please reference the Autopilot Servo Installation, Configuration, and Calibration chapter of your SkyView System Installation guide.
DYNON AVIONICS Servo Dimensions Use the following dimensions (in inches) for reference when planning and implementing your installation. Long-arm variants (not needed in most installations)have linkage mount holes at 1.5”, 1.75”, and 2.0” L Servo Mounting Instructions – RV-9 Roll Kit 101046-004 Rev G Weight SV32 2.17” 2 lb SV42 3.10” 3 lb SV52 4.
DYNON AVIONICS Linkage mount position force and travel The diagram below illustrates the maximum travel and force available at each linkage mounting point. As can be seen, the closer you mount the linkage to the shaft, the more force the servo can deliver. However, this also means the travel of the arm is shorter. Again, ensure that the servo arm is nowhere near going over-center throughout the entire range of the control system. Position B should be used in most RV-9 roll installations.
DYNON AVIONICS Servo Mounting Instructions – RV-9 Roll Kit 101046-004 Rev G 7
DYNON AVIONICS Servo Mounting Instructions – RV-9 Roll Kit 101046-004 Rev G 8
DYNON AVIONICS Servo Mounting Instructions – RV-9 Roll Kit 101046-004 Rev G 9
