Installation Guide Owner manual

Appendix
7-4 EMS-D10 Installation Guide
Appendix D: EMS-D10 Specifications
Mechanical
Fits into standard 3 1/8” panel hole
Optional flush mount bracket available
Operating
Temperature
-22° to 122° F (-30° to 50° C)
Power
Voltage: 10 - 30 Vdc
Power:
8 watts typical; 10 watts maximum
Connections
Wiring: DB25 female & DB37 male connectors
Screen
Type: AMLCD, TFT (Thin Film Transistor)
Backlight: 450 nits
Size: 3.8” diagonal (96 mm)
Resolution: 320 x 240 color pixels
Sensor Inputs
6 - EGT (Type K Thermocouple)
6 - CHT (Type J Thermocouple)
2 - Fuel Level (Resistive or Capacitance with 5 volt output)
2 - RPM (P-lead or pickup)
2 - Contacts
1 - Manifold Pressure (voltage)
1 - Oil Temperature (Resistive)
1 - Oil Pressure (Resistive)
1 - Fuel Pressure (Resistive)
1 - Fuel Flow (Frequency)
1 - Current (Shunt)
1 - Voltage (from supply power)
1 - Turbine Inlet Temperature (Type K Thermocouple)
3 - General Purpose (Either resistive or voltage for OAT, Fuel
Tanks 3&4, Coolant Temp, Coolant Press, Carburetor
Temp)
Inputs/Outputs
1 - Alarm Light Contact
1 - Audio Alarm
1 - RS-232 bidirectional PC communication
1 - RS-232 data input (GPS, SL30, etc.)
1 - Dynon Smart Avionics Bus (DSAB) differential