User Manual

EFIS-D60 Pilot’s User Guide 2-1
2. PRODUCT OVERVIEW
This section provides a general overview of the various parts of the EFIS-D60 as well as a theory of operation. The
information in this section serves as a reference only and helps familiarize you with the inner workings of the unit. It
should not be used fo r di ag nostic or reparat i v e wor k.
EFIS-D60 Hardware
The EFIS-D60 uses solid-state sensors to provide accurate and reliable information about your flying environment in an
easy-to-use interface.
POWER
The EFIS-D60 requires between 10 and 30 volts DC for operation. It is acceptable to have the EFIS-D60 turned on
during engine start.
The EFIS-D60 can be order e d with an optional internal battery which allows the instrument to continue to operate in the
event of an external power failure. This lithium-ion battery is rechargeable and is managed by the EFIS-D60. Under
normal conditions, the internal battery should have a voltage between 13 and 16.8 volts. When the battery’s voltage
drops below 13 volts, the EFIS-D60 d isplays a low battery warning. When new, a fully charged internal battery is rated
for a minimum of 1.5 hours of normal operation with the EFIS-D60. If the EFIS-D60 has switched to its internal
emergency battery due to a power loss in your aircraft, it is advised that you land as soon as possible.
SENSORS AND INPUTS
Attitude information is obtained from 3 solid-state gyrometers, 3 solid-state accelerometers, and the airspeed pressure
sensor. Heading information is obtained from 3 solid-state magnetometers housed in the EDC-D10A. Airspeed, altitude
and angle of attack are obtained from three separate pressure transducers.