Installation Guide Manual

EFIS-D10 Installation Manual
EFIS-D10 Installation Guide Doc Num: 100006-000 Rev. C
9/11/2003 Page 6 of 24
Required but not supplied
• Wire cutters
• Wire (22 AWG); see recommended wiring practices
• Connector crimp tool
• #2 Phillips screwdriver
• Two 7/16 wrenches
• Standard RS232 serial cable
• DB-25 Female connector with crimp pins
• D-9 Female connector with crimp pins for PC interface
• (optional) D-9 Female connector with crimp pins for EDC-D10 remote mount compass.
• Personal computer: running Windows 98 or higher; with at least 64 MB of RAM and a
serial port; preferably a laptop, but a desktop PC is sufficient.
• Tubes for routing pitot, static and AOA pressures to the unit.
• ½” wrenches