Owner manual

I15-7012
Wideband Commander Air Fuel Ratio Monitor Installation Guide - 1
PARTS LIST
quantity description
1 Wideband Commander Module
1 Wideband Commander Software
1 Bosch LSU 4 Wideband Oxygen Sensor
1 Oxygen Sensor Cable
1Power Supply
1Power Supply Cable
1USB Cable
3Cable Ties
1Dynojet Decal
SETTING UP THE WIDEBAND COMMANDER
1 Release the holding tabs by inserting a small
screw driver into the four back slots on the
Wideband Commander module.
2 Remove the back panel of the Wideband
Commander module.
3 Attach the O2 sensor wiring harness wires to
the screw terminal as shown in Figure B.
4 Replace the back panel. Verify the holding tabs
lock securely into the slots.
Note: Dynojet recommends securing the
sensor cable to the main wiring harness with a
cable tie for additional strain relief.
Figure AFigure B