Owner manual

PAGE 1
PAGE 2
©2008 Dynojet Research, Inc. All Rights Reserved. Wideband Commander Air Fuel Ratio Monitor Installation Guide For Dyno Interface. This manual is copyrighted by Dynojet Research, Inc., hereafter referred to as Dynojet, and all rights are reserved. This manual, as well as the software described in it, is furnished under license and may only be used or copied in accordance with the terms of such license.
PAGE 3
PARTS LIST quantity 1 1 1 1 1 1 1 3 1 description Wideband Commander Module Wideband Commander Software Bosch LSU 4 Wideband Oxygen Sensor Oxygen Sensor Cable Power Supply Power Supply Cable USB Cable Cable Ties Dynojet Decal SETTING UP THE WIDEBAND COMMANDER 1 Figure B Figure A 2 Release the holding tabs by inserting a small screw driver into the four back slots on the Wideband Commander module. Remove the back panel of the Wideband Commander module.
PAGE 4
Figure C 5 When using the compressed air setup to run the main air fuel ratio, remove the O2 sensor bung plug in the sensor block. 6 Install the Wideband Commander O2 sensor in the block along side the sensor that is already there. Note: The procedure is the same for the standup compressed air. 7 Connect the USB cable to the mini USB port on the Wideband Commander. Connect the USB cable to an available USB port on your dyno computer.