©1998-2001 Dynojet Research, Inc. All Rights Reserved. Tire Temperature Sensor Installation Guide This manual is copyrighted by Dynojet Research, Inc., hereafter referred to as Dynojet, and all rights are reserved. This manual, as well as the software described in it, is furnished under license and may only be used or copied in accordance with the terms of such license.
TABLE OF CONTENTS Tire Temperature Sensor Installation Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Technical Support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TIRE TEMPERATURE SENSOR INSTALLATION This document provides instructions for installing the tire temperature sensor. To ensure safety and accuracy in the procedures, perform the procedures as they are described.
T I R E TE M P E R A T U R E S E N S O R Introduction INTRODUCTION ................................... The tire temperature sensor allows you to monitor the temperature of the motorcycle tire. TECHNICAL SUPPORT For assistance, please contact Dynojet Technical Support at 1-800-992-3525, or write to Dynojet Research at 2191 Mendenhall Drive, North Las Vegas, NV 89081. Visit us on the World Wide Web at www.dynojet.
INSTALLATION GUIDE Installation INSTALLATION ................................... This section contains instructions for installing the tire temperature sensor. ASSEMBLING THE SENSOR 1 Mount the sensor bracket to the sensor bracket peg using the 10-32 screw. 10-32 screw sensor bracket sensor bracket peg Figure 2: Mount the Sensor Bracket 2 3 Mount the sensor to the sensor bracket. 2a Remove one of the nuts from the sensor. 2b Slip the sensor bracket on the sensor.
T I R E TE M P E R A T U R E S E N S O R Installation WIRING THE SENSOR 1 2 Remove the hood from the dyno. Attach the five wires on the cable coming from the tire temperature sensor to TEMP on the Breakout board as described below. • Green wire to G2 • White wire to W2 • Black wire to B2 • Red wire to R2 • Silver (ground) wire to S2 Note: Do not use G1 through S1. These are reserved for monitoring the brake temperature.
INSTALLATION GUIDE Installation SECURING THE MOUNTING BRACKET AND SENSOR ASSEMBLY 1 2 3 4 Replace the hood on the dyno. Secure the mounting bracket to the hood using the bolts removed earlier. Secure the magnetic base to the mounting bracket. Adjust the sensor so it is pointing at the center of the tire.
