POWER COMMANDER V Install guide for 22-100 Model coverage: 2022 Yamaha R7 PARTS LIST 1 POWER COMMANDER V 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 3 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. I22-099.
INPUT ACCESSORY GUIDE USB CONNECTION EXPANSION PORTS 1 & 2 INPUT 1 INPUT 1(Grnd) INPUT 2 INPUT 2 (Grnd) SPEED ANALOG CRANK ACCESSORY INPUTS Map (Input 1 or 2) The PCV has the ability to hold two different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important.
INSTALLING THE POWER COMMANDER V 1 Remove both seats, both side panels, the bodywork surrounding the fuel tank, the panel between the seats, and the plastic panel above the right footpeg. 2 Remove the fuel tank. 3 Lay the PCV in tail section. Route the PCV harness down the right side of the frame going towards the throttle bodies. 4 Attach the ground wire of the PCV to the negative (-) side of the battery. 5 Unplug the stock wiring harness from each injector.
6 Plug the PCV in-line of the stock wiring harness and each injector. PCV ORANGE wires go to the #1 cylinder (left) 7 Unplug the stock Throttle Position Sensor (TPS) connector. This is a BLACK 3-pin connector on the right side of the throttle bodies. 8 PCV Plug the PCV in-line of the TPS and stock wiring harness. Stock PCV 9 Unplug the stock wiring harness from the ignition coils.
10 Plug the PCV in-line of the stock ignition coils and wiring harness. PCV GREEN wires go to the #1 cylinder (left). 11 Unplug the stock wiring harness from the Crank Position Sensor connector. This connection is on the left side near the regulator/ rectifier. 12 Plug the PCV in-line of the stock wiring harness and CPS. 13 Using one of the supplied Velcro strips, secure the PCV module in the tail section. Use the supplied alcohol swab to clean the surface area prior to applying the Velcro.
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.