Installation Guide

PC6-22091
INSTALLING THE POWER COMMANDER 6
11 Plug the pair of RED/WHITE wires on the PC6 wiring
harness in-line of the right side Ignition Coil and
the stock BLACK/RED wire.
12 Plug the GREEN wire of the PC6 to the stock
BLACK/WHITE wire and plug the WHITE/GREEN
wire of the PC6 to the right side Ignition Coil.
13 On the left side Ignition Coil at the front of the bike,
unplug the stock BLACK/ORANGE wire from the
Ignition Coil.
14 Plug the BLUE wire of the PC6 directly to the stock
BLACK/ORANGE wire and the WHITE/BLUE wire of
the PC6 directly to the Ignition Coil.
15 Remove the rubber strap that holds the ECU in
place and move the ECU to the side to gain access
to the Crank Position Sensor connectors.
This connector pair is clear and has LIGHT GREY
and GREY colored wires going to it from the left side
engine cover.
16 Unplug the stock Crank Position Sensor
connectors.
CONNECT TO RH COIL
CONNECT TO LH COIL
UNPLUG CPS