Installation Guide

PC6-16074
1 Remove the seat, side covers, and radiator shrouds.
2 Remove the fuel tank.
3 Use the supplied Velcro to secure the PC6 module to
the top of the rear fender behind the battery.
Clean surfaces with the supplied alcohol swab before
attaching the Velcro.
4 Route the PC6 wiring harness forward towards the
engine following along the left side frame rail.
5 Secure the PC6 ground wire with the small ring
terminal to the negative (-) post of the bike’s battery.
6 At the top of the throttle body, loosen the MAP sensor
by removing the screw.
This allows you to access the Throttle Position Sensor
connector more easily.
INSTALLING THE POWER COMMANDER 6