Installation Guide

4 2001-2006 HONDA CBR600 F4i
INSTALLATION GUIDE
10 Continue routing the harness forward along the
inside of the left frame spar to the throttle body
sub-harness connector at the front of the fuel tank.
11 Locate and unplug the stock throttle body
sub-harness connector.
This is a GREY 10-pin connector. It may be located
under a rubber fl ap.
There is another identical connector on the bike
located under the fuel tank near the rear shock. DO
NOT plug the PC6 harness into it.
12 Plug the PC6 wiring harness in-line of the stock
throttle body sub-harness connectors.
13 Store the connectors under the tank. Bolt the front of
the fuel tank back down.
14 Reinstall the panel and seats.
Download the latest map fi les from our web site at
dynojet.com/tunes.
Optional Inputs:
Speed - PINK/GREEN wire on the GREY ECU connector
(pin #6).
Engine Temp - GREEN/BLUE wire on the thermostat
housing at the rear of the engine.
12v Source for Autotune - BROWN wire of the tail light
connector.