Installation Guide

ManualsBrandsDynojet ManualsOtherDYNOJET PC6-16046 Power Commander 6

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

PARTS LIST

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

IPC6-16046.01

POWER COMMANDER 6

Installation Guide for: PC6-16046

Model Coverage: 2001-2006 Honda CBR600 F4i

Summary of content (5 pages)

PAGE 1
POWER COMMANDER 6 Installation Guide for: PC6-16046 Model Coverage: 2001-2006 Honda CBR600 F4i PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-16046.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG CRANK OPTIONAL ACCESSORY INPUTS Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 1 Remove the main seat and the passenger seat. 2 Remove the BLACK left-hand side inner fairing panel. This panel surrounds the gauges down to the fuel tank. It is held in place by two bolts. 3 Prop the front of the fuel tank up. 4 Using the supplied Velcro, secure the PC6 module in the tail section as far back as possible. Clean both surfaces with the supplied alcohol swab prior to applying the Velcro adhesive.
PAGE 4
10 Continue routing the harness forward along the inside of the left frame spar to the throttle body sub-harness connector at the front of the fuel tank. 11 Locate and unplug the stock throttle body sub-harness connector. This is a GREY 10-pin connector. It may be located under a rubber flap. There is another identical connector on the bike located under the fuel tank near the rear shock. DO NOT plug the PC6 harness into it.
PAGE 5
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.