Installation Guide

4 2008-2010 HONDA CBR125R
INSTALLATION GUIDE
6 Locate the TPS on the left
side of the bike.
7 Using the supplied
Posi-tap, attach the
unterminated GREY wire of
the PCV wiring harness to
the stock YELLOW/BLACK
wire of the TPS.
It is recommended to use
dielectric grease on these
connections.
The wire-tap used in this
picture is not a Posi-tap. This is an older crimp-on
style wire-tap.
8 Remove the battery cover and attach the PC6 ground
wire to the negative side of the battery.
9 Using the supplied Velcro, secure the PC6 in the tail
section.
Clean both surfaces with the supplied alcohol swab
prior to applying the Velcro adhesive.
10 Bolt the fuel tank back into place. Reinstall the
seats.
Download the latest map fi les from our web site at
dynojet.com/tunes.