Installation Guide

ManualsBrandsDynojet ManualsOtherDYNOJET PC6-16021 Power Commander 6

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

1 POSI-TAP

PARTS LIST

IPC6-16021.01

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

POWER COMMANDER 6

Installation Guide for: PC6-16021

Model Coverage: 2008-2010 Honda CBR125R

Summary of content (5 pages)

PAGE 1
POWER COMMANDER 6 Installation Guide for: PC6-16021 Model Coverage: 2008-2010 Honda CBR125R PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS 1 POSI-TAP PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-16021.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG CRANK OPTIONAL ACCESSORY INPUTS Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 PC6-16021 1 Remove both seats. 2 Prop the front of the fuel tank up. 3 Lay the PC6 in the tail section and route the cable along the frame. 4 Disconnect the stock connector from the bikes fuel injector, this connector is covered by a rubber boot. 5 Plug the PC6 connectors in-line with the stock wiring harness and the fuel injector.
PAGE 4
6 Locate the TPS on the left side of the bike. 7 Using the supplied Posi-tap, attach the unterminated GREY wire of the PCV wiring harness to the stock YELLOW/BLACK wire of the TPS. It is recommended to use dielectric grease on these connections. The wire-tap used in this picture is not a Posi-tap. This is an older crimp-on style wire-tap. 8 Remove the battery cover and attach the PC6 ground wire to the negative side of the battery. 9 Using the supplied Velcro, secure the PC6 in the tail section.
PAGE 5
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.