Installation Guide

PC6-14042
1 Lift the rear section.
2 Remove the left hand side fairing.
3 Locate the plug that resides in between the two
throttle bodies. This plug has a round, silver retaining
ring on the end of it.
4 Unscrew this connector by turning it counter-
clockwise.
Note: You may want to route the wires for the PC6
from the tail section to this area before plugging it
in. This will make for a cleaner installation.
5 Plug the female connector from the PC6 into the
stock wiring harness.
6 Plug the male connector from the PC6 into the stock
female connector on the bracket.
INSTALLING THE POWER COMMANDER 6