Installation Guide

PC6-14019
12 Plug the pair of PC6 leads with ORANGE colored
wires in-line of the front fuel injector and stock wiring
harness.
13 Remove the right hand fairing.
14 Route the PC6 harness along the right hand side
frame down tube. Use the existing wraps to hold the
PC6 harness in place.
15 Locate the Throttle Position Sensor (TPS) on the right
hand side of the throttle bodies.
16 Using the supplied posi-tap, attach the PC6 grey wire
to the stock orange wire of
the bikes TPS (pin position
C).
The wire tap shown is not
a posi-tap; it is an older
crimp-on style wire tap.
17 Attach the ground wire
from the PC6 to the right
hand engine cover bolt.
18 Reinstall the right hand
fairing.
19 Using the supplied Velcro, install the PC6 in the tail
section.
Make sure to use the supplied alcohol swab to clean
both surfaces before attaching the Velcro.
20 Reinstall all of the bodywork, the seat, the solo cover,
and the fuel tank. When lowering the fuel tank, make
sure it does not interfere with the connection of the
rear injector.
Note: The PC6 will not be able to make fuel changes
below 20% throttle and below 5500 RPM when the
bike is in closed loop.
Optional Inputs:
Speed - grey/white wire of 3-pin connector (grey/white -
blue/orange - green)
Engine Temperature - white/blue wire - behind battery
on front cylinder
12v Source for Autotune - Yellow wire of tail light
connector - 5-pin connector under the seat
Download the latest map fi les from our web site at
dynojet.com/tunes.