Installation Guide

4 2009-2011 DUCATI 1198
INSTALLATION GUIDE
7 Route the PC6 along the right hand side of the
subframe. Secure the PC6 harness to the subframe
using two of the large supplied zip ties.
8 Unplug the stock wiring harness from the rear fuel
injector.
This injector is located on top of the air box.
To remove the connector you must fi rst remove the
spring clip. This is best done with a pick or small
screwdriver.
9 Plug the PC6 leads with YELLOW colored wires from
the PC6 in-line of the stock wiring harness and rear
fuel injector.
Make sure to reinstall the spring clip on the stock
connector.
10 Use the smaller supplied zip tie to secure this
connection to the fuel line.
Make this connection as compact as possible.
11 Unplug the stock wiring harness from the front fuel
injector.
This connection is very diffi cult to access. It is best
to get to through the front of the bike directly above
the radiator. This image was taken from the front of
the bike inside the right hand fairing and above the
radiator.