Installation Guide

ManualsBrandsDynojet ManualsOtherDYNOJET PC6-14019 Power Commander 6

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

3 ZIP TIES

1 POSI-TAP

PARTS LIST

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

IPC6-14019.01

POWER COMMANDER 6

Installation Guide for: PC6-14019

Model Coverage: 2009-2011 Ducati 1198

Summary of content (6 pages)

PAGE 1
POWER COMMANDER 6 Installation Guide for: PC6-14019 Model Coverage: 2009-2011 Ducati 1198 PARTS LIST 1 POWER COMMANDER 6 2 VELCRO STRIPS 1 INSTALLATION GUIDE 1 ALCOHOL SWAB 1 USB CABLE 3 ZIP TIES 2 DYNOJET DECALS 1 POSI-TAP 2 POWER COMMANDER DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-14019.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG OPTIONAL ACCESSORY INPUTS CRANK Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 PC6-14019 1 Remove the seat and solo cover. 2 Remove the cover around the fuel tank. 3 Remove the fuel tank. 4 Remove the inner fairing cover on the right hand side. 5 Lay the PC6 in the tail section temporarily. 6 Route the PC6 harness through the hole in the tail section.
PAGE 4
7 Route the PC6 along the right hand side of the subframe. Secure the PC6 harness to the subframe using two of the large supplied zip ties. 8 Unplug the stock wiring harness from the rear fuel injector. This injector is located on top of the air box. To remove the connector you must first remove the spring clip. This is best done with a pick or small screwdriver. 9 Plug the PC6 leads with YELLOW colored wires from the PC6 in-line of the stock wiring harness and rear fuel injector.
PAGE 5
12 Plug the pair of PC6 leads with ORANGE colored wires in-line of the front fuel injector and stock wiring harness. 13 Remove the right hand fairing. 14 Route the PC6 harness along the right hand side frame down tube. Use the existing wraps to hold the PC6 harness in place. 15 Locate the Throttle Position Sensor (TPS) on the right hand side of the throttle bodies. 16 Using the supplied posi-tap, attach the PC6 grey wire to the stock orange wire of the bikes TPS (pin position C).
PAGE 6
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.