Installation Guide

PC6-14013
1 Remove the left and right side panels.
2 Using the supplied Velcro, secure the PC6 module to
the battery.
Make sure to use the supplied alcohol swab to clean
both surfaces before attaching the Velcro.
3 Secure the PC6 ground wire with the small ring lug to
the negative (-) battery terminal.
4 Locate the Throttle Position Sensor (TPA) on the left
side of the throttle body.
5 Unplug the stock connector from the bike’s TPS to
gain access to the wiring harness.
6 Using the supplied Posi-
tap, attach the single
unterminated GREY wire
of the PC6 to the stock
ORANGE wire of the bike’s
TPS wiring harness.
This is pin position C on
the stock TPS connector.
The wire tap shown is not
a Posi-tap. This is an older
crimp-on style wire tap.
7 After attaching the GREY
wire, plug the stock TPS connector back onto the
TPS.
INSTALLING THE POWER COMMANDER 6