Installation Guide

ManualsBrandsDynojet ManualsPower CommanderDynojet Multistrada 1100 Power Commander

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

1 ZIP TIE

1 POSI-TAP

PARTS LIST

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

IPC6-14013.01

POWER COMMANDER 6

Installation Guide for: PC6-14013

Model Coverage: 2007-2009 Ducati Multistrada 1100

Summary of content (5 pages)

PAGE 1
POWER COMMANDER 6 Installation Guide for: PC6-14013 Model Coverage: 2007-2009 Ducati Multistrada 1100 PARTS LIST 1 POWER COMMANDER 6 2 VELCRO STRIPS 1 INSTALLATION GUIDE 1 ALCOHOL SWAB 1 USB CABLE 1 ZIP TIE 2 DYNOJET DECALS 1 POSI-TAP 2 POWER COMMANDER DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-14013.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG OPTIONAL ACCESSORY INPUTS CRANK Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 1 Remove the left and right side panels. 2 Using the supplied Velcro, secure the PC6 module to the battery. Make sure to use the supplied alcohol swab to clean both surfaces before attaching the Velcro. 3 Secure the PC6 ground wire with the small ring lug to the negative (-) battery terminal. 4 Locate the Throttle Position Sensor (TPA) on the left side of the throttle body. 5 Unplug the stock connector from the bike’s TPS to gain access to the wiring harness.
PAGE 4
8 Route the PC6 wiring harness up to throttle bodies. It is possible to install the PC6 without removing the fuel tank and the air box, although removing them may aid in the install. 9 Unplug the stock wiring harness from the rear fuel injector. 10 Plug the pair of PC6 leads with YELLOW colored wires in-line of the stock wiring harness and the rear fuel injector. 11 Route the PC6 harness under the throttle bodies to the right side of the bike.
PAGE 5
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.