Manual

Compressed Air Air Fuel Ratio Module Installation and User Guide
CHAPTER 1
Compressed Air Pump Assembly
1-8
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
COMPRESSED AIR PUMP ASSEMBLY
This section describes how to set up the compressed air pump assembly. Refer to
Appendix A for on-board dyno installation instructions.
COMPRESSED AIR REQUIREMENTS
The following requirements are needed for the compressed air pump assembly:
• Clean and dry air, 100 psi or greater, 5 CFM or better flow
• 1/4-inch NPT pipe thread connector (to attach air to the solenoid or pump ball
valve)
• optional air regulator
SETTING UP THE STAND ASSEMBLY
Secure the upright to the base using three 1/4-20 x 5/8-inch pan-head torx screws.
Figure 1-5: Stand Assembly
upright
screw
base