Installation Guide

5 PC6-10010
11 Plug the PC6 in-line of the stock wiring harness and
each ignition coil.
PC6 GREEN wires go to the #1 cylinder (left)
12 Unplug the stock wiring harness from the Throttle
Position Sensor.
This connector is on the backside of the right hand
side throttle body. To remove the connector you
need to slide the yellow tab towards the left. Then
squeeze the tab and slide the connector off to the
left.
14 Unplug the stock wiring harness from the Crank
Position Sensor.
This connector is on the backside of the engine just
above the starter. It is a WHITE 2 pin connector
on the harness side and a BLACK connector on the
stator side.
13 Plug the PC6 in-line of the stock wiring harness and
TPS.