Installation Guide

3 PC6-10010
INSTALLING THE POWER COMMANDER 6
6 Remove the stock airbox lid by removing the screws
around the perimeter.
Unplug the IAT sensor at the back of the airbox
1 Remove both seats, both side panels, and the
bodywork surrounding the fuel tank.
2 Remove the fuel tank.
3 Remove the tray on top of the battery.
4 Lay the PC6 in tail section. Route the PC6 harness
down the right side of the frame going towards the
throttle bodies.
5 Attach the ground wire of the PC6 to the negative (-)
side of the battery.