POWER COMMANDER 6 Install guide for PC6-10010 Model coverage: 2021-2022 Aprilia RS660 2021-2022 Aprilia Tuono 660 PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 3 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-10010.
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG OPTIONAL ACCESSORY INPUTS CRANK Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
INSTALLING THE POWER COMMANDER 6 1 Remove both seats, both side panels, and the bodywork surrounding the fuel tank. 2 Remove the fuel tank. 3 Remove the tray on top of the battery. 4 Lay the PC6 in tail section. Route the PC6 harness down the right side of the frame going towards the throttle bodies. 5 Attach the ground wire of the PC6 to the negative (-) side of the battery. 6 Remove the stock airbox lid by removing the screws around the perimeter.
7 Remove the airbox base by removing the 4 bolts around the throttle bodies. Remove the crankcase breather hose at the front of the airbox base. 8 Unplug the stock wiring harness from each injector 9 Plug the PC6 in-line of the stock wiring harness and each injector. PC6 ORANGE wires go to the #1 cylinder (left) - stock BLACK connector 10 Unplug the stock wiring harness from each ignition coil.
11 Plug the PC6 in-line of the stock wiring harness and each ignition coil. PC6 GREEN wires go to the #1 cylinder (left) 12 Unplug the stock wiring harness from the Throttle Position Sensor. This connector is on the backside of the right hand side throttle body. To remove the connector you need to slide the yellow tab towards the left. Then squeeze the tab and slide the connector off to the left. 13 Plug the PC6 in-line of the stock wiring harness and TPS.
15 Plug the PC6 in-line of the stock wiring harness and CPS. 16 Reinstall the tray on top of the battery. 17 Secure the PC6 inside the tray using the supplied velcro. Make sure to clean the surface with the alcohol swab before attaching. 18 Reinstall the fuel tank and bodywork. Download the latest map files from our web site at dynojet.com/tunes.
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.
